Your Hard Drive is one of
those components inside your computer that is mostly likely to fail as the
system gets older. This is because it is a mechanical device that uses motors,
and other moving parts that are guaranteed to wear out.
Before you remove the system
unit cover to gain access to your hard drive, remember to remove any and all
ESD (Electrical Static Discharge) from your body. This is done by touching an
object such as a doorknob or the case of the system unit. After this safety precaution
is done, remove the system unit cover and locate the drive.
Depending on the location of
old your Hard Drive, you may have to remove other components just to have
access to it. If so, take very good notes of everything you disconnect or
remove, you can refer to them later as you replace the components. Look to be
sure you have empty drive bays to install extra drives should you decide to add
a second drive.
Once the drive is clear of
other cables and components, carefully remove the power and data cable from the
drive and remove the drive retaining screws. Some drives are mounted on rails,
if this is the case, just slide the unit out through the front or top of the
system unit chassis.
Separate the drive from the
rail and now install the new drive to the rail. Watch those screws, they are
small and can be easily lost. Remember to ground yourself from time to time to
remove electrical static buildup. Watch this short video to see the Drive being
installed in the system unit.
When the drive is mounted on
the rail, (if you have one) write down any information on the front of the
drive that may give you the type, model number, sectors, cylinders, access time
and other information that seem important. You may need it when you configure
the hard drive. Nearly all new hard drives have software that does this for
you.
After being certain that all
cables, connections and all other components are in place, replace the system
unit cover, reconnect all peripherals to the system unit and plug it into the
wall outlet.
Turn on the computer. Now you
will need to tell the computer that it has a new or different hard drive. You
will have to start your PC with a bootable floppy disk if you replaced or installed
a new hard drive.
If your new drive came with an
owner's manual, keep it handy for future reference and you may need it to
config your drive. Even though you have installed the drive with its cable, the
computer doesn't know that you have done this. So we must tell the PC and while
we are at it, we must make the drive useable by partitioning and formatting it.
Your Hard is a delicate device
and will wear out soon. Learn about the types of Hard Drives, how to remove and
install them quickly. Doing so will save you on downtime with your computer and
you'll earn extra cash by installing new drives for your relatives and friends.
